Advanced Vehicle Functions includes vehicle control, drivetrain, braking, loading, implement and towing functions.
Note: Four-wheel drive and differentials must be purchased separately in the shop for each desired vehicle.
Important: The key bindings must be configured; nothing has been preset.
Features
- Analog joystick control for throttle and brake
- Switchable analog drive lever
- Glow plug system for cold engines
- Display of engine speed and engine temperature in the HUD
- Functional handbrake
- Sounds when applying and releasing the handbrake
- Sounds from the four-wheel drive and differentials
- Selectable four-wheel drive
- Separate differential locks for the front and rear axles
- Realistic compressed-air braking system for vehicles
- Simulated air pressure from 0 to 10 bar
- Speed-dependent compressor output
- Air consumption when braking and using the handbrake
- Air consumption when connecting a compressed-air trailer
- The handbrake cannot be released if the air pressure is too low.
- Reduced braking performance at low tire pressure
- Load-dependent vehicle center of gravity
- Dynamic load shifting in curves and on slopes
- Increased risk of tipping due to loaded trailers and raised implements
- Increased pushing force from heavy trailers on downhill sections
- Load loss with covers open and at higher driving speeds (minor)
- Detection of rollovers and vehicle accidents
- Spillage or loss of bulk material after an accident (must be loaded with a front loader)
- Towing service for damaged vehicles
- Towing costs are calculated based on the distance to the repair shop.
- Joint lifting and lowering of front-mounted implements
- Joint lifting and lowering of rear-mounted implements
- Simultaneous lifting and lowering of all attached implements
- Separate activation and deactivation of front and rear implements
- Simultaneous activation and deactivation of all implements
- Separate folding and unfolding of front and rear implements
- Simultaneous folding and unfolding of all implements
- The camera automatically rotates in the interior view when reverse gear is engaged. This can be disabled in the general settings.
- The helper automatically applies the handbrake in helper mode.
- Automatic drivetrain (intelligent automatic control of four-wheel drive and differential). The four-wheel drive has 2 systems and can be engaged at any time.
- The slight vibration of the interior camera is intended to simulate the running engine.
- The front loader can be raised and lowered faster at idle by increasing the throttle (engine speed).
- When starting the engine, the key or button (ignition switch) must be held down for 0.8 seconds; otherwise, the vehicle will not start (this is intended to simulate a real ignition switch).
